Star Tech Development LC-4521 Manuel d'utilisateur télécharger pdf (Page 22)

14 Printer Setup

❏ Close the tractor covers. At this point you can make ﬁnal adjustments to the

paper position by releasing the gray levers and moving the tractors. The

paper should lie ﬂat with no buckling or bulging (tractors too close) or no

stretching or elongation of the holes (tractors too far apart). After making

these adjustments, be sure that you re-lock the tractors by pushing the gray

levers back into their original positions.

❏ Before printing, make sure that the leading edge of the fanfold paper

extends about 0.8 inch (two centimeters) past the front the paper chute, as

shown in the illustration below.

❏ Close the rear cover and press down gently on it until it locks into place

with a click.

Caution!

Since printing with an open rear cover may cause paper feeding problems, be

sure to close the rear cover before printing.

0.8”(2cm)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 114 115

Pas de commentaire

Star Tech Development LC-4521 Manuel d'utilisateur Page 22